Dell PowerVault MD3420 - Manual (Page 33)

Object Type Identifier
snapGroup A snapshot group contains a sequence of snapshot
images of an associated base virtual disk. A snapshot
group has a repository virtual disk that is used to
save data for all of the snapshot images that are part
of the snapshot group.
snapGroupName Virtual disk group user label
storageArray Not applicable
enclosure Enclosure ID
virtualDisk Virtual disk user label or the World Wide Identifier
(WWID) for the virtual disk (set command only)
virtualDiskCopy Target virtual disk and, optionally, the source virtual
disk user labels
diskGroup Virtual disk group number
Statement data is in the form of attribute=value (such as raidLevel=5), an attribute name (such as
batteryInstallDate), or an operation name (such as consistencyCheck).
Script Command Synopsis
Because you can use the script commands to define and manage the different aspects of a storage array
(such as host topology, physical disk configuration, RAID controller module configuration, virtual disk
definitions, and disk group definitions), the actual number of commands is extensive. The commands,
however, fall into general categories that are reused when you apply the commands to the different
aspects of a storage array.
The following table lists the general form of the script commands and provides a definition of each
command.
Table 6. General Form of the Script Commands
Command Syntax Description
activate object {statement ‑ data} Sets up the environment so that an operation can
take place or performs the operation if the
environment is already correctly set up.
autoConfigure storageArray{statement-data} Automatically creates a configuration based on
parameters specified in the command.
check object {statement ‑data} Starts a synchronous operation to report on errors
in the object.
clear object {statement ‑ data} Discards the contents of some attribute of an
object. This is a destructive operation that cannot
be reversed.
create object {statement ‑ data} Creates an object of the specified type.
deactivate object {statement ‑ data} Removes the environment for an operation.
delete object Deletes a previously created object.
33