Dell PowerVault MD3420 - Manual (Page 286)

Syntax
set hostChannel [hostChannelNumber]
preferredID=portID
Parameters
Parameter Description
hostChannel The identifier number of the host channel for
which you want to set the loop ID.
The host channel identifier number is constructed
by combining the RAID controller module number
and the host channel number. Enclose the host
channel identifier number in square brackets ([ ]).
Separate the RAID controller module number from
the host channel number with a comma.
For example, the identifier number for host
channel 2 on RAID controller module 0 would be
[0,2].
preferredID The port identifier for the specified host port. Port
ID values are 0 to 127.
Set Host Group
Description
This command renames a host group.
Syntax
set hostGroup [hostGroupName]
userLabel="newHostGroupName"
Parameters
Parameter Description
hostGroup Name of the host group to rename. You must put
brackets ([ ]) around the host group name. If the
host group name has special characters, you must
also put quotation marks (" ") around the host
group name.
userLabel New name for the host group. You must put
quotation marks (" ") around the host group name.
NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the
names. Command names can have a maximum of 30 characters. If you exceed the maximum
character limit, replace square brackets ([ ]) with angle brackets (< >) to overcome this limitation.
286