Dell PowerVault MD3420 - Manual (Page 389)

Stop Snapshot Image Rollback
Description
This command stops a snapshot image rollback operation that was initiated by the start snapImage
rollback command.
NOTE: Canceling a snapshot image rollback operation leaves the base virtual disk in an
indeterminate state with potentially invalid or inconsistent data. The related snapshot image virtual
disk becomes disabled and unusable.
Syntax
stop snapImage [snapImageName] rollback
Parameter
Parameter Description
snapImage The name of the snapshot image for which you
want to stop a rollback operation. The name of a
snapshot image is comprised of two parts:
• The name of the snapshot group.
• An identifier for the snapshot image in the
snapshot group.
The identifier for the snapshot image can be one of
these:
• An integer value that is the sequence number
of the snapshot in the snapshot group.
• NEWEST - Use this option when you want to
show the latest snapshot image created in the
snapshot group.
• OLDEST - Use this option when you want to
show the earliest snapshot image created in the
snapshot group.
Enclose the snapshot image name in double
quotation marks (" ") inside square brackets ([ ]).
Notes
The name of a snapshot image has two parts separated by a colon (:):
• The identifier of the snapshot group
• The identifier of the snapshot image
For example, if you want to stop a rollback operation for snapshot image 12345 in a snapshot group that
has the name snapGroup1, you would use this command:
stop snapImage ["snapGroup1:12345"] rollback;
389