Dell PowerVault MD3420 - Manual (Page 215)

Parameters
Parameter Description
allVirtualDisks This parameter deletes all of the virtual disks on a
disk pool.
virtualDisk or virtualDisks The name of the virtual disk that you want to
delete. You can enter more than one virtual disk
name. Enclose the virtual disk name in square
brackets ([ ]). If the virtual disk name has special
characters, you also must enclose the virtual disk
name in double quotation marks (" ").
removeDiskGroup Deleting the last virtual disk in a disk group does
not delete the disk group. You can have a
standalone disk group (minus any virtual disks). To
remove the standalone disk group, set this
parameter to TRUE. To keep standalone disk
groups intact, set this parameter to FALSE.
force Use this parameter to force the immediate deletion
of a virtual disk even if the RAID controller modules
are performing other operations. To immediately
force the deletion of a virtual disk, set this
parameter to TRUE. To wait until the RAID
controller modules have finished performing other
operations, do not use this parameter or set this
parameter to FALSE.
schedule
retainRepositoryMembers When you delete a thin virtual disk, the associated
repository virtual disk is deleted by default.
However, when the retainRepositoryMembers
is set to TRUE, the repository virtual disk is retained.
For normal virtual disks, this parameter has no
effect.
Notes
When you use the allVirtualDisks parameter, this command deletes virtual disks until all of the
virtual disks are removed or until an error is encountered. If an error is encountered, this command does
not try to delete the remaining virtual disks. Deleting virtual disks from different disk groups is possible. All
of the disk groups that become empty are deleted if you set the removeDiskGroup parameter to TRUE.
Diagnose RAID Controller Module
Description
This command runs diagnostic tests on the RAID controller module.
215