Dell PowerVault MD3420 - Manual (Page 339)

Syntax
show (allRAIDControllerModules | raidControllerModule [(0 | 1)]) NVSRAM
[hostType=(
hostTypeIndexLabel | host="hostName")]
Parameters
Parameter Description
allRAIDControllerModules Returns information about both RAID controller
modules in the storage array.
raidControllerModule Returns information about a specific RAID
controller module in the storage array. Valid RAID
controller module identifier values are 0 and 1. The
identifier value is 0 for the RAID controller module
on the top and 1 for the RAID controller module
on the bottom when viewed from the rear of the
enclosure. You must put brackets ([ ]) around the
RAID controller module identifier.
hostType Specifies the index label or number of the host
type. Use the show storageArray
hostTypeTable command to generate a list of
available host type identifiers.
host Specifies the name of the host connected to the
RAID controller modules. You must put quotation
marks (" ") around the host name.
NOTE: Use the show raidControllerModule NVSRAM command to display parts or all of the
NVSRAM before using the set raidControllerModule command to change NVSRAM values.
Show Remote Replication Group
Description
This command displays configuration information for one or more remote replication groups. This
command also displays the remote replicated pairs associated with each remote replication group,
including incomplete remote replicated pairs.
You can also use this command to show the progress of periodic data synchronization on all of the
replicated pairs within the remote replication group.
Syntax
show (allAsyncRemoteReplicationGroups |
asyncRemoteReplicationGroup ["asyncRemoteReplicationGroupName"])
[summary]
339