Welch Allyn Connex Integrated Wall System - User Manual - Manual (Page 136)

Unit of measure Select the primary unit of measure for the SpHb
display on the Home tab.
Default averaging Select the default moving window of time used by
the parameter to calculate the SpHb value and
update the display: short (approximately 1 minute),
medium (approximately 3 minutes), or long
(approximately 6 minutes).
Trend view time Select the period displayed in the SpHb trend
graphic on the Home tab.
5. Do one of the following:
• To continue in the Advanced Settings, touch another tab.
• To exit the Advanced tabs and return to the Home tab, touch Exit.
Specify advanced pulse rate settings
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.
2. Touch the Parameters tab.
3. Touch the Pulse rate tab.
4. Specify settings.
Setting Action/Description
Display source Select this to show the source of pulse rate
measurements (NIBP or SpO2) on the Home tab.
5. Do one of the following:
• To continue in the Advanced Settings, touch another tab.
• To exit the Advanced Settings and return to the Home tab, touch Exit.
Specify the manual parameters
The Manual Parameters frame is in the lower right corner of the Home tab. You can manually enter
values for parameters in the frame. You also can specify which parameters appear in the frame.
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.
2. Touch the Parameters tab.
3. Touch the Manual tab.
130 Advanced settings Welch Allyn Connex ® Integrated Wall System