Welch Allyn Connex Integrated Wall System - User Manual - Manual (Page 141)

Method Select a method. Then touch and enter
characters: Network key (64 characters), or
Passphrase (8 to 63 characters).
Security protocol Select the security protocol.
EAP type Select the EAP type.
Identity Enter the EAP identity (maximum of 32 characters).
Password Enter the EAP password (maximum of 32
characters).
Key number Select the WEP key number.
Key Enter the WEP key (10 characters for WEP 64, or 26
characters for WEP 128).
Configure radio Touch Configure radio to activate all new
radio settings not selected previously.
Touch
OK in the confirmation popup telling you to
power down the monitor.
Touch the
Settings tab. Touch the Device tab.
Touch Power down .
The radio will reboot.
Note If you do not touch Configure radio ,
none of the changed radio settings will take effect.
5. Do one of the following:
• To continue in the Advanced Settings, touch another tab.
• To exit the Advanced Settings and return to the Home tab, touch Exit.
Specify server settings
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.
2. Touch the Network tab.
3. Touch the Server tab.
4. Specify settings.
Setting Action/Description
Obtain server IP information automatically Enable the monitor to automatically obtain the
server IP information via the network.
UDP broadcast port : Touch and enter
the port number that is used to automatically obtain
server IP information. The range of entry is 0 to
65535.
Directions for use Advanced settings 135