Welch Allyn Connex Integrated Wall System - User Manual - Manual (Page 32)

3. Properly orient and insert the sensor cable into the patient cable connector. (You just
connected the opposite end of the sensor cable to the wall system.) Ensure the sensor cable is
inserted completely, then close the protective cover. (See the sensor manufacturer's
directions for use.)
4. Wrap the excess patient cable around the spool, and place the finger clip in the holder.
Connect the blood pressure (NIBP) hose
1. Align the hose connector with the hose connector port on the bottom of the monitor.
2. Insert the hose connector, pressing firmly until it clicks into place.
3. Attach a blood pressure cuff to the tubing (see the cuff manufacturer's directions for use),
then store the cuff in the accessory bin.
26 Setup Welch Allyn Connex ® Integrated Wall System