Welch Allyn Connex Integrated Wall System - User Manual - Manual (Page 70)

2. On the General tab, modify audio alarm notification.
• To enable or disable audio alarms, select Alarm audio on or Alarm audio off.
If you turn off audio alarms, visual alarm signals still occur in the LED light bar, Device
Status area, and on the Home tab in parameter frames.
The in the Device Status area indicates alarm audio turned off, and a similar bell
will appear in the parameter frames . If an alarm condition occurs, the bell will be
red or amber in the alarming frame, according to the priority of the alarm, as shown here:
or .
• To modify the volume of audio alarms: Select a volume level.
An audio tone sounds briefly to indicate the volume level.
Note Periodically test the speaker by selecting different speaker
volumes and listening for the different tones.
Alarm messages and priorities
The following tables list the physiological and technical alarm messages and their priority.
Physiological alarms
Alarm messages Priority
Alarm limit exceeded. NIBP systolic HIGH. High
Alarm limit exceeded. NIBP systolic LOW. High
64 Alarms Welch Allyn Connex ® Integrated Wall System