Welch Allyn Connex Integrated Wall System - User Manual - Manual (Page 34)

2. Hold the temperature probe cable connector with the spring tab on the right and insert it into
the probe port of the temperature module. Push it into place until it clicks.
3. Insert the temperature probe into the probe well.
4. Open a box of probe covers and place it in the probe cover box holder.
Note Spare boxes of probe covers can be stored in the compartment on
the top of the wall system.
Set up the Braun ThermoScan® PRO 4000 thermometer
If your system is configured for the Braun ThermoScan thermometer, follow these setup
instructions.
1. Remove the thermometer from the package and discard the protective casing. Then open a
box of probe covers and place it in the dock.
28 Setup Welch Allyn Connex ® Integrated Wall System