Welch Allyn Connex Integrated Wall System - User Manual - Manual (Page 36)

Note New batteries are only 30 percent charged. You must plug the wall
system into AC power to fully charge the battery. Do not plug in the
power cord until completing all preliminary steps.
2. Proceed to Startup.
Attach an accessory
1. Shut down the wall system and detach the power cord. Then remove the cover from the wall
system by loosening the captive retention screws.
2. Loosen the two screws on the cable retention clamp and remove it. Then connect the USB
cable(s) to an available connector and thread the cable(s) through the cable guide(s).
3. Replace the cable retention clamp and tighten the two screws.
4. Re-attach the cover.
a. Thread the SpO2 (or SpHb) cable through the cutouts on the top right and bottom left of
the cover.
30 Setup Welch Allyn Connex ® Integrated Wall System