Welch Allyn Connex Integrated Wall System - User Manual - Manual (Page 26)

CAUTION Do not remove the cardboard securing the handles on
the left side of the wall system at this time. The cardboard prevents
damage to those instruments during the mounting process.
Mounting hardware inventory
Use these items to mount the wall system.
6 x
• Mounting rail bracket
• Accessory bin bracket
• Screws
Tools list
Use these tools to mount the wall system.
•
#2 Phillips screwdriver
• level
• tape measure
• stud finder
• drill
• 1/8-inch (3.17 mm) diameter drill bit
Mounting location
Before mounting the wall system, consider the following recommendations to determine the best
mounting location:
•
Mount the wall system to studs.
• Mount the wall system within reach of the AC power outlet. The power cord is 8 ft. (2.44 m)
long.
• Avoid brightly lit areas.
• Blood pressure tubing is 8 ft. (2.44 m) long.
20 Setup Welch Allyn Connex ® Integrated Wall System