Welch Allyn Connex Integrated Wall System - User Manual - Manual (Page 33)

Set up the physical assessment instrument handles and
specula dispenser
1. Attach the specula dispenser. Ensure that the keyhole locking slots on the back of the
dispenser engage the locking screws on the wall system, then push down firmly.
2. Remove cardboard securing instrument handles.
3. Attach Welch Allyn 3.5V instrument heads of your choice to the handles. See the directions for
use for each instrument head.
Set up the SureTemp® Plus thermometer
If your wall system is configured for a SureTemp Plus thermometer, follow these setup
instructions.
1. Align the probe well with the tabs facing up and down and insert the probe well into the
temperature module.
The probe well snaps into place when it is fully seated.
Directions for use Setup 27