KEYENCE IG Series - Manual (Page 130)

6-2 Before Use
6-8
6
IG Config
u
ra
tion Softw
a
re (
IG-
H1)
IG-E
RS-232C
Communication test
Perform the test to check if the communication with the IG is possible.
Default
Return the setting of DL-RS1A to the factory default (default value).
3
Make the communication setting and click [OK]. The display returns to the
[How to start] dialog box.
If the [Cancel] button is clicked, the communication setting returns to the pre-
changed status and the display returns to the [How to start] dialog box.
4
Select the starting method and click [OK].
Click [Cancel] button to finish the IG Configurator.
Item Description
COM port
Setting range : Displays all the COM ports equipped with the
PC If the COM ports are not present on the PC,
the display shows blank and communication
with the IG is not available.
Default value : COM1
Baud rate
Setting range : 2400 / 4800 / 9600 / 19200 / 38400
Default value : 9600bit/s
Data bit length
Setting range : 7 / 8
Default value : 8
Parity check
Setting range : None/Even/Odd
Default value : None
Note • Before clicking [Communications test], check if the PC and the
IG Series are properly connected.
• Confirm that the IG is turned on.
• Confirm the DL-RS1A read/write setting switch is set to RW. If the
read/write setting switch is set to R, communication is not possible.
Item Description
Configu-
ration
Read out the configu-
ration data from IG. Reads the configuration data stored on the IG
main unit and starts.
Create a new
configuration file.
Creates a new configuration file.
Open a
configuration file.
Opens a configuration file stored on the PC.
Monitor
Start monitoring for
IG. Communicates with the IG Series main unit and
starts in the monitoring status.
Reference When selecting "Create a new configuration file." or "Open a
configuration file." to start, step 2 and 3 can be skipped.