KEYENCE IG Series - Manual (Page 160)

A-10 IG-E
Append
ix
3
Factory Setting (Default Value) List
This section describes the factory settings (default values).
If the initial reset is performed, the default values will be restored as below except for the
calibration function.
"3-5 Initial Reset (Initialize)" (page 3-10)
Values set on the main screen
The bank 0 to 3 have the same value.
Basic Settings and Advanced Settings
Other functions
Setting items Default value
HIGH side setting value .
LOW side setting value .
Shift target value .
Setting items Default value Description
1. Measurement mode C.GFI Edge control/Positioning mode
2. Measurement direction VQR Top
3. Average number of times
(Response time)
 Average number of times:16
4. Output mode PQ Normal Open
5. Hold function J Sample hold
6. Timing input NGXGN Level
7. Delay timer QHH The delay timer is not used.
8. Hysteresis . 0.02 mm
9. Edge check function QHH The edge check function is not used.
10. Analog output scaling FGHNV Default setting (Not scaled)
11. External Input FGHNV Default setting
12. Saving the standard waveform function OQHH Not save on the nonvolatile memory (EEPROM)
13. Saving zero shift value function OQHH Not save on the nonvolatile memory (EEPROM)
14. Interference prevention function QHH Interference prevention function OFF
15. Display digit . Truncate a number to 3 decimal places
16. Power saving indication QHH Not display the power saving (Normally ON)
17. Position monitor FGHNV Normal
18. Display color IQITP GO green
Setting items Default value Description
Measurement sensitivity FGHNV Standard mode
Calculation Function QHH The calculation function is not used.
Calibration Function FGHNV Standard