KEYENCE LS-7600 - Manual (Page 108)

5-46
Chapter 5 Function Settings
5
Setting Method
1
Press the [Up or Down] key and move the cursor to A–OUT+10 or A–OUT–10.
2
Press the [ENT] key.
The cursor moves to the “+” position and the value can be input.
3
Press the [Up or Down] key and
select + or –.
4
Press the [Left or Right] key and
move the carsor between digits to
input the value.
OUT1
A-OUT+10 + 3 0 .00000
A-OUT -10 0.00000
A-SET OFF
A-CONT +10.5V
5
Press the [Up or Down] key to input
the value.
6
Repeat step (4) and (5) until all the
digits are input.
OUT1
A-OUT+10 + 3 0 .00000
A-OUT - 10 0.00000
A-SET OFF
A-CONT +10.5V
7
Press the [ENT] key.
The input items are entered and the cursor returns to A–OUT+10 or A–OUT–10.
Note: If there is any input value error, the value will not be entered but the cursor will
return to the setting item.
■
Analog Update Mode
The measured value will not be held after area calculation, but instead will be subjected
to analog scaling and output.
1
Press the [Up or Down] key and move the cursor to A–SET.
2
Press the [ENT] key.
The cursor moves to the setting item.
3
Press the [Up or Down] key and
select ON or OFF.
4
Press the [ENT] key.
The input item is entered and the cursor
returns to A-SET.
OUT1
A-UNIT 1000um/V
A-SET OFF
A-CONT +10.5V