KEYENCE LS-7600 - Manual (Page 29)

1-15
1
Chapter 1 Getting Started
Gasket
Secure these portions
with screws.
The stand must be located on
the groove from which the gasket
was removed.
4
Secure the mounting brackets with a
Phillips screwdriver.
• Tighten the mounting screws to a maximum torque of 0.4 Nm.
Do not tighten up the mounting screws excessively, otherwise
the panel or controller casing may be deformed.
• Do not remove the gasket, otherwise the controller will not
satisfy IP64 conditions.
CAUTION
■ Mounting to AC Power Supply Stand
The following section provides information on how to mount the controller to the AC
power supply stand (sold separately). The AC power supply stand consists of a stand
unit and base unit. Mount the controller to the stand unit first. Connect the power supply
cable, extension cable (i.e., the cable between the controller and measuring head), and
camera cable. Then mount them to the base unit.
1
Remove the gasket around the
controller.
2
Mount the controller to the stand.
Use the two screws provided with the
package and secure the controller on the
side.