KEYENCE LS-7600 - Manual (Page 42)

3-2
3
Chapter 3 Easy Setting Guide
Measurement of Outer Diameter and Width (with Single Measuring Head)
In the following example, a single measuring head is used to measure the outer diameter
of an object in one direction. The result of measurement is displayed as OUT1.
D
Measures the outer diameter in one direction.
■ Set Values
Set item
Calibration
Tolerance setting
Area setting
Output
setting
AREA
Operation
Averaging
RUN mode
Offset
Set value
AREA 1
Head 1 DIA
Make settings if required.
A1: +1
A2: 0
Select the value according to the line speed.
Normal
No settings are required.
No settings are required.
No settings are required.
Set the upper and lower limit values.
AREA 2
OUT 1 OUT 2
■
Reference
Area Settings (Page 5-9)
Calibration Settings (Page 5-22)
Output Settings (Page 5-29)
Tolerance Settings (Page 5-49)