KEYENCE LS-7600 - Manual (Page 72)

5-10
Chapter 5 Function Settings
5
4
Press the [Up or Down] key and move the cursor frame to the area to be set.
To set 2, press the [Up or Down] key and move the cursor frame to AREA2.
5
Press the [ENT] key.
Area Selection
Area
When a target is located in the measuring area as shown below, the light into the
receiver is partly obstructed, thus creating a shadow.
The contour of the shadow is called “edge.” The area is surrounded by the edge line.
The LS-7600 Series can measure objects with area designation or edge designation.
Area designation is possible in DIA, T-EDGE, or B-EDGE mode. Edge designation is
possible in SEG mode.
EDGE
EDGE
EDGE
EDGE
AREA
AREA Target
Transmitter Receiver
AREA
■
DIA (Diameter)
When the LS-7600 Series is in DIA measurement operation, it measures the outer
diameters of round bars or transparent
objects. The area between the top of the
first shadow and the bottom of the last
shadow is measured as shown in the
illustrations.
Transmitter
Target
Receiver
This space is
measured.
Transmitter Receiver
This space is
measured.
Target