KEYENCE LS-7600 - Manual (Page 45)

3-5
3
Chapter 3 Easy Setting Guide
Measurement of Inner Diameter and Clearance
In the following example, the inner diameter of the workpiece is measured while the
workpiece moves. The maximum value measured is taken as the inner diameter of the
workpiece. The result of output is displayed as OUT1.
■
Set Values
Set item
Calibration
Tolerance setting
Area setting
Output
setting
AREA
Operation
Averaging
RUN mode
Offset
Set value
AREA 1
Head 1 SEG
(+1E, +2E)
Make settings if required.
A1: 1
A2: 0
Select the value according to the line speed.
Peak hold
No settings are required.
No settings are required.
No settings are required.
Set the upper and lower limit values.
AREA 2
OUT 1 OUT 2
■ Reference
Area Settings (Page 5-9)
Calibration Settings (Page 5-22)
Output Settings (Page 5-29)
Tolerance Settings (Page 5-49)