KEYENCE LS-7600 - Manual (Page 71)

5-9
Chapter 5 Function Settings
5
Area Settings
Area settings are used to determine the measurements taken from a variety of objects
placed in the beam. The LS-7600 Series can use up to two measuring heads to set two
measurements (AREA1 and AREA2) for simultaneous measurements.
Area Settings
Area settings include the following items.
• Area:
Select the measuring head number together with
the DIA, T-EDGE, B-EDGE, or SEG mode.
• Area display: Turn the cursor on the target viewer ON or OFF.
• Focus monitor: A function to check whether the target is within the
measuring range. Set the best measuring range
(i.e., the distance between the target and transmit-
ter) with this function.
• Area check: Set the total number of edges to be measured. If
the number of edges detected does not coincide
with the set value, the measured value will be
invalidated.
• Difference check: If there is a radical change between measured
values, the change will be detected and output.
Set the value for the change to be detected.
• Function output selection: Set the items to be output from the output terminal
on the rear panel.
• Edge detection threshold change: Set the threshold to be detected when measuring
highly transparent objects.
Area Setting Procedure
Make area settings while checking the display on the LCD monitor.
The following procedure is for area settings through the remote control console.
1
Set the [Slide Switch] key to PROG.
2
Press the [Up or Down] key to move
the cursor to the AREA.
AREA1
HEAD
1
AREA DIA
A-DISP ON
FOCUS 5
A-TEST OFF
AREA2
HEAD
1
AREA DIA
A-DISP ON
FOCUS 5
A-TEST OFF
CAM1
PROG
P – 00
LIMIT
AREA
OUTPUT
CALIB
OPTION
A1 2
A2 2
01/02/18
17:50:42
3
Press the [ENT] key.
The cursor frame will be displayed for
AREA1.
AREA1
HEAD
1
AREA DIA
A-DISP ON
FOCUS 5
A-TEST OFF
AREA2
HEAD
1
AREA DIA
A-DISP ON
FOCUS 5
A-TEST OFF
CAM1
PROG
P – 00
LIMIT
AREA
OUTPUT
CALIB
OPTION
A1 2
A2 2
01/02/18
17:50:42