KEYENCE LS-7600 - Manual (Page 119)

5-57
Chapter 5 Function Settings
5
1
Press the [Up or Down] key and move the cursor to T-MODE.
2
Press the [ENT] key.
The cursor moves to the setting item.
3
Press the [Up or Down] key and select
the timing input.
The following table lists available setting
items with corresponding displays on the
LCD monitor.
Asynchronous mode ASYNC
Setting LCD monitor
Synchronous mode SYNC
4
Press the [ENT] key.
The input item is entered and the cursor
returns to T-MODE.
LIMITS DEV
T-MODE ASYNC
D-UNIT mm
D-RES 0.00005
C-OUT SUB
GRAPH-T
OUT1 1m
OUT2 1m
STATS
OUT1 OFF
OUT2 OFF
GROUP OFF
APP-MODE OFF
Display Unit
The display unit of measured values can be changed.
Select the display unit from the following.
• mm:
Displayed in millimeters.
•
μ
m: Displayed in micrometers.
• UNIT1: Displayed in inches.
• UNIT2: Displayed in mils (0.001 inch = 1 mil).
The displayed decimal position changes as shown below with the display unit changed.
CAM1
RUN
P – 00
01/02/18
17:50:42
1 2 . 3 4 5 6 0
μ m/mils mm/inch
CAM1
RUN
P – 00
01/02/18
17:50:42
1 2 3 4 . 5 6 0
Note: When the display unit is changed, all set values will be reset to default values
(e.g., output set values and tolerance set values). Refer to page 5-60 for
default values in millimeters and micrometers and available value setting
ranges.