KEYENCE LS-7600 - Manual (Page 26)

1-12
1
Chapter 1 Getting Started
■ With TR Base
The transmitter and receiver are mounted to the TR base at the time of shipment. This
section provides how to install the transmitter and receiver (LS-7030M in this case) that
are mounted on the TR base. LS-7010M and LS-7070M can also be installed in the
same way.
Use the four, M4x20 Allen-head bolts, which
are provided with the package, to mount the
TR base. To mount the TR base with the
bolts on the surface of the TR base, use the
mounting holes on the surface.
To mount the TR base with the bolts on the
back of the TR base, use the 10-mm-deep
M4 (10-mm-deep M5 for LS-7070M)
mounting holes on the back.
■ Without TR Base
Take the following steps to use the transmitter and receiver (LS-7030M in this case) after
dismounting them from the TR base. LS-7010M and LS-7070M can also be used in the
same way.
1
Loosen the bolts on the back of the
TR base and remove the measuring
head.
2
Mount the measuring head.
Use the side mounting holes on the
transmitter and receiver as shown in
the illustration. Mount them with the
bolts provided with the package.