KEYENCE LS-7600 - Manual (Page 38)

2-2
2
Chapter 2 Basic Operation of the LS-7600 Series
Control Panel Functions and Nomenclature
The LS-7600 Series is operated with the panel keys and remote control console. The LCD
monitor will display the result of measurement and necessary data for setting.
Panel Key Functions
LS-7601
[SCREEN] key
Press this key to change the screen display.
(Page 4-2, Section 4-1 Switching Display
Screen)
[STATS] key
Press this key to use the statistical
processing function.
(Page 5-66, Section 5-10 Group
Processing)
[RUN/PROG] key
Press this key to change the LS-
7600 Series between RUN mode
and PROG mode.
[PRINT] key
Press this key to print out the screen
display.
[HOLD] key
Press this key to hold the measured value. The
key has the same function as the TIMING input
terminal on the rear panel.
(Page 4-9, Section 4-3 Hold Function)
[PROGRAM No.] key
Press this key to change the
program number.
(Page 4-12, Section 4-6 Program
Changes)
[ESC] key
Press this key to quit or abort the
set item. When in the Run mode,
this key has the same function as
the RESET input terminal on the
rear panel.
[ENT] key
Press this key to input the set value
change.
[Cursor] key
Press this key to move the cursor or
make set value changes.
[ZERO] key
Press this key to use the automatic zero
function. The key has the same function
as the ZERO input terminal of the rear
panel.
(Page 4-10, Section 4-4 Automatic Zero
Function)
SCREEN
STATS
RUN
PROG
PROGRAM No.
ESC
PRINT
ENT
ZERO HOLD
POWER
■
Cursor Keys
Four cursor keys (i.e., the Up, Down, Left,
and Right keys) are available. Each key is
used for the following purposes.
• To move between set items.
• To input numeric values, such as toler-
ance values.
Moving right Moving left
Moving up
Moving down