Measurement Computing Analyzer488 - Manual (Page 123)

Section 4 Serial Controller
4.29
data are the management line and data line status (two hex bytes
for each event) . Data is dependent on the contents of the
record memory.
checksum is the one's complement of record length plus
address plus all data bytes.
The last line sent is the S9 record which is
always: S9030000FC
Format of data bytes is:
Byte 1 Byte 2
(bit positions) (bit positions)
(Control and Status Lines) (Data Lines)
8 7 6 5 4 3 2 1 8 7 6 5 4 3 2 1
REN IFC SRQ EOI BERR VALIDTRIG ATN D8 D1
If a bus management or data line is asserted, its corresponding bit
will be true (1).
MODE Any
BUS STATES None
QUERY None
RESPONSE
EXAMPLES 10 PRINT#1,"ERASE" Clear the record memory.
20 PRINT#1,"CONTROLLER ON" Select High level control
30 PRINT#1,"SET TRIGGER OFF" Do not use triggering
40 PRINT#1,"RECORD ON" Start recording bus events
50 PRINT#1,"OUTPUT 20;W3X" Send the command W3X
60 PRINT#1,"RECORD OFF" Stop recording bus events
70 PRINT#1,"DUMP 0 TO 8" Dump the first 9 locations
80 IF LOC(1) THEN PRINT INPUT$(LOC(1),1);
90 GOTO 80
The following response will be returned:
S1150000854A853F853484778433847884840D940A0000C1
S9030000FC