2 last, 3 next trigger, 4 previous trigger – Measurement Computing Analyzer488 User Manual
Page 206
Section 5
Analyst488 Software
5.18
For an extremely long capture sequence, it is possible that the record
memory may be overwritten one or more times. In this case, the first
recorded event may be at a higher location than the last recorded event.
5.10.2 Last
This command places the cursor on the last recorded event in the most
recent recorded sequence.
For an extremely long capture sequence, it is possible that the record
memory may be overwritten one or more times. In this case, the last
recorded event may be at a lower location than the first recorded event.
5.10.3 Next Trigger
When more than one record sequence is performed without first
erasing the record memory, it is possible to have more than one trigger point
in the record memory of the Analyzer488. This command places the cursor
on the next location (a location recorded after the present location) that was
marked as a trigger point.
If multiple record sequences were performed, it is possible that the
record memory may be overwritten one or more times. In this case, the next
trigger location may be at a lower location than the current trigger location.
5.10.4 Previous Trigger
When more than one record sequence is performed without first
erasing the record memory, it is possible to have more than one trigger point
in the record memory. This command places the cursor on the previous
location (a location recorded before the present location) that was marked as
a trigger point.
If multiple record sequences were performed, it is possible that the
record memory may be overwritten one or more times. In this case, the
previous trigger location may be at a higher location than the current trigger
location.