Measurement Computing Analyzer488 - Manual (Page 256)

Appendix B Serial Controller Command Summary
B.2
ERROR ERROR[;]{[?]|MESSAGE|NUMBER|OFF]}
Enable or disable automatic error reporting.
FIND FIND{[?]|[MATCH][state][line][<byte>]
[
ERROR]|[TRIGGER][START{location}][+|-]}
Search the record memory for a specific bus event
HANDSHAKE HANDSHAKE{[?]|[FAST|STEP|NONE|SLOW{<rate>}]}
Set the bus handshaking speed.
HELLO HELLO
Read the Analyzer488 revision identification.
ID ID;[ASCII]
Change the ID character.
KEY KEY[?]
Read the Analyzer488 Keyboard.
LISTEN LISTEN[?]
Go to Listen state and perform an acceptor handshake
LOCAL LOCAL[addr[,addr ...]]
Unassert the Remote Enable (REN) line.
LOCAL LOCKOUT LOCAL LOCKOUT
Issue the Local Lockout (LLO) bus command.
MASK MASK{[ON|OFF]}
Mask the high bit of serial input data.
MEASURE MEASURE[0|1]
Return the speed of bus events in bytes per second.
NEXT NEXT
Find the next targeted bus event in record memory.
OUTPUT OUTPUT[addr[,addr ...]][#count];data
Send data to IEEE 488 bus device.
PPOLL PPOLL
Read the Parallel Poll response from all bus devices.