Measurement Computing Analyzer488 - Manual (Page 85)

Section 3 Front Panel Operation
3.39
[STEP] to perform handshaking). Select with [
↑] and [↓] cursor
keys. Accept entry with [ENTER] and [EXIT] or cancel with
[ESC]
.
[MEASURE] The Measure command, [SHIFT][SETUP], displays post trigger
bus event performance. Data menus show the time, number of bytes,
and transfer rate of the last triggered recording operation.
Time 0.000 mSeconds
Amount of time that elapsed during the post trigger recording. Time
can be from 0.001 milliseconds to 999.9 seconds. Use the [
↑] and
[
↓] cursor keys or [ENTER] to display further measure information,
[EXIT] or [ESC] will exit.
Count 00000 Bytes
Number of events that occurred during the post trigger recording.
Count
will be from 0 to 32767. Use the [
↑] and [↓] cursor keys
or [ENTER] to display further measure information. [EXIT] or
[ESC]
will exit.
Rate 0.000 B/sec
Speed of the transfer which occurred during the post trigger
recording. Rate will be from 0.001 Bytes per second (B/sec) to
1.100 megabytes per second (Mbyte/sec). Use the [
↑] and [↓]
cursor keys to display further measure information. [ENTER],
[EXIT]
or [ESC] will exit.
[ARM] The Arm key, [ARM], is used to enable or disable the triggering
system while recording data. When recording, [ARM] will cause the
Arm LED to flash until the trigger condition is satisfied then remain
on until the trigger sequence is complete. Also see [SETUP] and
[MEASURE]
. While the Analyzer488 is NOT recording data,
[ARM] has no effect.
ARM LED The Arm LED, when flashing, indicates the triggering system is