Measurement Computing Analyzer488 - Manual (Page 127)

Section 4 Serial Controller
4.33
ERROR
The ERROR command enables or disables automatic reporting of Analyzer488
error messages. When enabled, error messages are returned when commands are
completed. ERROR MESSAGE enables error message string reporting, ERROR
NUMBER
enables error message number reporting, and ERROR OFF disables error
reporting. ERROR OFF is the factory default condition.
The query option, ERROR?, returns the ERROR command option currently in
use.
TYPE System command
SYNTAX ERROR[;]{[?]|[MESSAGE|NUMBER|OFF]}
MODE Any
BUS STATES None
QUERY String in the following format:
RESPONSE ERROR MESSAGE NUMBER OFF
EXAMPLES PRINT#1,"ERROR OFF" Disable error message reporting.
PRINT#1,"ERROR MESSAGE" Enable error message reporting.
INPUT#1,A$:PRINT A$ Response is error message or: OK
PRINT#1,"ERROR?" Query current error mode.
INPUT#1,A$ Get response
PRINT A$ "ERROR MESSAGE"