Measurement Computing Analyzer488 - Manual (Page 264)

Appendix D Analyst488 Software Menus
D.2
Record (Alt R)
Record Enable (F8) Start or stop recording bus events
record Status... Get recording statistics
Trigger setup... Configure triggering parameters
triGger enable Start or stop triggering
Erase (^E) Erase the record memory
Zero (^Z) Reset record memory pointer
Search (Alt S)
First Display first recorded bus event
Last Display the last event recorded
Next Trigger Search for the next trigger point
Previous Trigger Search for the previous trigger point
mark/Unmark Block (F6) Mark a block of data
Mark all (^M) Mark all data
Block find... Search a marked block for data
block find Next (F9) Find next data in a marked block
block Compare Compare two marked blocks
goto Address (^G) Cursor to an absolute address
goto Offset (^O) Cursor to a relative address
goto Reference Cursor to relative address 0
Handshake (Alt H)
Listen (^L) Put Analyzer488 in listen state
Talk (^T) Put Analyzer488 in talk state
Fast Set handshake to high speed
Slow... Set handshake to 1 to 10 bps
steP (F10) Enable and step one handshake
None Disable handshake participation