Remote – Measurement Computing Analyzer488 User Manual
Page 158
Advertising
Section 4
Serial Controller
4.64
REMOTE
The REMOTE command asserts the Remote Enable (REN) bus management line.
If optional bus addresses are specified, then REMOTE addresses those devices to listen,
placing them in the Remote Addressed state.
This command does not have a query option.
TYPE
High Level Controller command
SYNTAX
REMOTE [addr[,addr
...]]
addr
is an IEEE 488 bus device address
RESPONSE
None
MODE
High Level Controller
BUS STATES
REN (without addresses)
REN,
ATN•UNL, MTA, LAG (with addresses)
QUERY
None
RESPONSE
EXAMPLES
PRINT #1,"REMOTE"
Assert Remote Enable
PRINT #1,"REMOTE16,28"
Assert Remote Enable and
address devices 16 and 28 to
listen.
Advertising