Wavecom W74PC V8.7.0 - Manual (Page 322)

312

Additional Functions WAVECOM Decoder W74PC, W-PCI/e, W-CODE, W-CLOUD Manual V8.7.0
WAVECOM Server
Introduction
The WAVECOM Server and the WAVECOM Server Control applications are used to setup and monitor the
connections between decoder cards (clients) and the server. The server is responsible for managing the
decoders connected to the computer, as well as all the connections made to that decoder. The WAVECOM
Server is started by the GUI for a local connection (GUI and card on the same host) or by the Server Con-
trol for a remote connection. The WAVECOM Server is started as a Service.
When the server has been started a traffic light icon is displayed in the Windows System Tray. Right-
clicking the icon displays a menu:
If the server is stopped, you CANNOT restart it using Restart. You must click Exit, and then go to Start |
Programs | WAVECOM | WXXX | WavecomServerControl to restart the server.
WAVECOM Server Control
After restart of the server, the WAVECOM Server Control screen is displayed.
Card Information
Card information is available from the Card Information tab:
 Card names
 Number of connections to the card, including local and remote connections
 Device name
 Card serial number
Setting Up Card Names
A maximum of eight cards may be connected to a single computer. Each of these cards has a name asso-
ciated with it; the card names can be used to establish a connection to a specific card. The default names
are "DeviceA" through to "DeviceH". It is possible to change the card names by: