Remote control – Wavecom W74PC V8.7.0 User Manual
Page 330
320
Additional Functions
WAVECOM Decoder W74PC, W-PCI/e, W-CODE, W-CLOUD Manual V8.7.0
Comp. Status
Explanation
Connected
The Serial Link application (client) is connected to the selected computer (serv-
er)
Disconnecting...
The Serial Link application is being disconnected
Disconnected
The Serial Link application is disconnected
Card Status
Explanation
Initialize...
The card is being initialized. Each card needs to be initialized when a connection
is made to that card for the first time
Running
The card is ready and active
Error
A general error occurred and the card is in an error state
Error loader
The software could not be downloaded to the card
Card in use
Another application is accessing the card
No card
A card is not connected at that address
Timeout
A time out error occurred
Err dev driver
A device driver error occurred
Err drv conflict
The device driver is not correctly set up
Port Status
Explanation
Initialize...
The COM port is being initialized
Idle
The COM port is ready, but data is not currently being transmitted
Traffic
Data is being sent to the COM port
Error
A general error occurred and the COM port is in an error state
Timeout
A time out error occurred
No port
The selected COM port is not available or is in use
Overflow
The COM port is congested. Check port settings and increase the baud rate
Remote Control
The decoder uses Microsoft TCP to communicate between the server and the user interface.
This structure allows a number of decoders to be remotely controlled from a single PC. Selecting a decoder
for remote control is simply done using the Configuration menu.
When using remote control, the operating details remain unchanged.
Details see “
XML
See separate documentation.