Wavecom W74PC V8.7.0 User Manual
Page 69
WAVECOM Decoder W74PC, W-PCI/e, W-CODE, W-CLOUD Manual V8.7.0
First start
59
Right (PCM) or Left & Right (IQ)
Sampling Rate [Hz]
The sampling rate is fixed at 48 kHz
Note: If the GUI is running in remote mode, the names of the sound cards installed on the remote com-
puter which hosts the WAVECOM decoder are listed.
Add a new TCP/IP Custom Input
Select the Configuration | Custom Inputs... menu entry to open the configuration dialog for the custom
inputs.
To use a TCP/IP stream as signal input source, the following parameters have to be set via the Custom
Inputs dialog:
Input Parameter
Value
Input Name
The name of the custom input
Device
Select Network in the list
Port number
Enter the a port number. The data source must be configured with the same port num-
ber
Format
IP-CONF, IP-PXGF or VITA-49 (for more information, see “
on page 321)
Sampling Rate (Hz)
The sampling rate used by the data source
Number of channels
Number of channels
Channel
In the list box the channel(s) to be used are displayed: Mono, Left, Right, Left +
Right (PCM) and Left & Right (IQ).
Add a new VITA-49 Custom Input
VITA-49 is a standardized stream format which is specified in ANSI/VITA-49.
To use a TCP/IP stream with VITA-49 format as signal input source, the following parameters have to be
set via the Custom Inputs dialog: