Wavecom W74PC V8.7.0 - Manual (Page 63)

WAVECOM Decoder W74PC, W-PCI/e, W-CODE, W-CLOUD Manual V8.7.0 First start

53
Settings...
Clicking Setttings... opens a configuration window.
You can enable or disable different options, to control the behavior of the application:
 When selecting "Print" include front page containing all mode settings. Enable or disable
the printing of a status page with all mode settings if you use the Print command.
 When selecting "Clear Screen" show warning before deleting all data. Enable or disable
the display of a warning window before the screen is cleared when you use the Clear Screen
command.
 When selecting "Exit" save last mode. Enable or disable storing of settings from the last
mode. If enabled, the decoder will start again in the latest mode used.
 When selecting "FFT" and "PSK Symbol Rate" pause graphics while cursors are active.
Enable or disable the automatic freezing of the graphic as long as the cursors are displayed.
 Enable the Backspace support. Sometimes in modes like PSK-31, the operator is sending back-
space characters. If backspace support is enabled, backspace will work as for an ordinary terminal
program.
 Enable reconnect to cards on remote computer. Enable or disable the GUI to reconnect to a
card on a remote computer. If enabled, the decoder will reconnect to the card on the remote com-
puter.
 Enable relative frequency display. You can select if, in the FFT, sonagram etc displays, the “re-
al frequency” (center frequency+offset) or the “relative frequency” is displayed.
Receiver and Satellite Settings...
These settings are used for satellite modes and analysis, and give the operator the possibility to configure
receiver or down-converter frequencies, and to select a satellite and receiver type. The receiver or down-
converter control interface to be controlled is connected to a serial port of the computer. Receiver center
frequency is preconfigured to 1542 MHz for the L-Band settings and 3544.5 MHz for the C-Band settings.