Paradyne 4200 - Manual (Page 144)

6. Cross Connect Commands
6-10 August 2002 4200-A2-GB20-00
RTRV-CRS-VC
The RTRV-CRS-VC command retrieves the configuration of an ATM Interface
Virtual Channel cross-connection.
Table 6-7. RTRV-CRS-VC Command Parameters
RTRV-CRS-VC:[tid]:aid_vci:[ctag]::::[pstf];
RESTRICTIONS: All parameters in this command are position-defined. The range of
values for vpi and vci is determined by the number of VPI and VCI bits allocated.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
aid_vcl Virtual Channel Identifier for the Virtual Circuit. The value can be
preceded with AID=, but this is not required. Grouping and ranging are
allowed. Enter in the following formats, replacing lower-case parameters
with the values given:
NTVCL-vpi-vci: VCL in the NT
LTVCL-rack-shelf-_slot-circuit-vpi-vci: VCL in an LT circuit
– rack: Rack number (1)
– shelf: Shelf number (1)
– lt_slot: LT slot number (1)
– circuit: ADSL circuit on the LT (1
−
24)
– vpi: Virtual Path Identifier
– vci: Virtual Channel Identifier
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
[pstf] Selects a range of states from the Bellcore state model. Valid values
are:
IS: Matches IS-NR
OOS: Matches OOS-MA, OOS-AU, OOS-AUMA
AU: Matches OOS-AU, OOS-AUMA
MA: Matches OOS-MA, OOS-AUMA
Grouping and ranging are allowed. If no value is specified, ALL is
assumed.