Paradyne 4200 - Manual (Page 58)

3. ADSL Facility Commands
3-22 August 2002 4200-A2-GB20-00
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/* ED-PROFILE-ADSLUPALM:[tid]:adsl_profile_id:[ctag]:::
[adslprof_nblk] */
;
Error Response:
sid yy-mm-dd hh:mm:ss
M c DENY
/* ED-PROFILE-ADSLUPALM:[tid]:adsl_profile_id:[ctag]:::
[adslprof_nblk] */
errcde
;
[adslprof_nblk]
(continued)
DECRATE-F: Decreasing Rate (fast channel). SNMP rate change trap
and TL1 autonomous message are sent if the current rate is
≤
the
previous rate minus this threshold (0-2176 kbps in 32 kbps increments,
where 0 disables the messages). The default is 0.
INITFAIL: Initialization Failure. Enables or disables InitFailureTrap
messages specified in RFC 2662.
– Y: Enable Initialization Failure Trap messages only.
– N: Disable Initialization Failure Trap messages only (Default).
If not specified, the values of these parameters remain unchanged.
Table 3-17. ED-PROFILE-ADSLUPALM Command Parameters (2 of 2)
ED-PROFILE-ADSLUPALM:[tid]:adsl_profile_id:[ctag]:::[adslpr
of_nblk];