Paradyne 4200 - Manual (Page 210)

10. Fault Commands
10-18 August 2002 4200-A2-GB20-00
RTRV-ATTR-ALL
The RTRV-ATTR-ALL command retrieves current attributes of all conditions
maintained by the NE.
Table 10-11. RTRV-ATTR-ALL Command Parameters (1 of 2)
RTRV-ATTR-ALL:[tid]:aid_all:[ctag]::[ntfcde],[cond_all],
[locn],[dirn];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] The identification of the target NE. TID is optional and has a default
value of null. The NE's SID code is the only other valid value.
aid_all_adsl Access Identifier for all entities. The value is ALL.
[ctag] The correlation tag that correlates an input command with its associated
output response(s). It is assigned by the originator of the command. The
value is limited to six characters, which may be an identifier or a decimal
numeral. It is optional with a default of 0.
[ntfncde] Notification code. Valid values are:
CR: Critical alarm
MJ
:
Major alarm
MN: Minor alarm
NA: Not alarmed (reported via REPORT EVENT)
NR: Not reported (information is stored in the NE). This value is
supported for the ADSL condition NOPEER (no peer ATU present).
Grouping is allowed. If no value is specified, ALL is assumed.
[cond_all] Condition. Values are:
ACTLPBK: Facility placed in loopback.
AIS: Alarm Indication Signal
EQPT: Equipment failed self-test
FACTERM: Modem could not initialize
FANALAM-1: Alarm for Fan 1
FANALAM-2: Alarm for Fan 2
LCD: Loss of ATM cell delineation
LCD-F: Loss of Cell Delineation (Fast)
LOF: Loss Of Frame
LOFS-L: Loss Of Frame Seconds (Line)
LOL: Loss Of Link
LOLS-L: Loss Of Link Seconds (Line)
ES-L: Errored Seconds (Line)
SES-L: Severely Errored Seconds (Line)
UAS-L: Unavailable Seconds (Line)
INCRATE-F: Increasing Rate (Fast channel). There is no corresponding
standing condition clear message.