Paradyne 4200 - Manual (Page 311)

15. Test Commands
4200-A2-GB20-00 August 2002 15-13
STP-LAMPTST
The STP-LAMPTST command stops a lamp (LED) test on a device.
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/* STP-LAMPTST:[tid]:aid_eqpt:[ctag][:] */
;
Error Response:
sid yy-mm-dd hh:mm:ss
M c DENY
/* STP-LAMPTST:[tid]:aid_eqpt:[ctag][:] */
aid_eqpt:ERRCDE=errcde
/* error description */
;
Table 15-11. STP-LAMPTST Command Parameters
STP-LAMPTST:[tid]:aid_eqpt:[ctag];
RESTRICTION: All parameters in this command are position-defined.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
aid_eqpt Equipment access identifier. The value can be preceded with AID=, but
this is not required. Grouping and ranging are allowed. Enter in the
following format, replacing lower-case parameters with the values
given:
COM: Common equipment system identifier.
Grouping and ranging are not allowed.
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.