Paradyne 4200 - Manual (Page 225)

10. Fault Commands
4200-A2-GB20-00 August 2002 10-33
DENY Input command is denied
/* */ Enclosed are human readable comments – unspecified format
errcde Error code (see Appendix A, Error Codes )
aid Access Identifier of the entity reporting the alarm. Valid values are:
SHELF-rack-shelf
NTA
LTA-rack-shelf-slot
ADSL-rack-shelf-slot-circuit
NTT1-circuit
aid_type The type of Access Identifier. Valid values are ADSL, EQPT, and T1.
[ntfncde] Notification code. Values are:
CR: Critical alarm
MJ: Major alarm
MN: Minor alarm
NA: Not alarmed (reported via REPORT EVENT)
NR: Not reported (information is stored in the NE). This value is
supported for the ADSL condition NOPEER (no peer ATU present).
cond As described for command parameters (see Table 10-19,
RTRV-COND-ALL Command Parameters ), except that ALL is not used.
[serveff] Service effect. Values are:
SA: Service affecting
NSA: Not service affecting
[locn] Location of the condition. Valid values are:
NEND: Near End
FEND: Far End
[dirn] Signal direction. Valid values are:
RCV: Receive
TRMT: Transmit
Table 10-20. RTRV-COND-ALL Response Parameters (2 of 2)
Parameter Explanation