Paradyne 4200 - Manual (Page 190)

9. Performance Commands
9-10 August 2002 4200-A2-GB20-00
REPT-OPSTAT-VCL
The REPT-OPSTAT-VCL command reports operational parameters for a Virtual
Channel Link (VCL) on an NT or LT.
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/* REPT-OPSTAT-VCL:[tid]:aid_vcl:[ctag][:] */
"aid_vcl:op_vcl,value"
;
Error Response:
sid yy-mm-dd hh:mm:ss
M c DENY
/* REPT-OPSTAT-VCL:[tid]:aid_vcl:[ctag][:] */
"aid_VCL:ERRCDE=errcde"
/* error description */
;
Table 9-7. REPT-OPSTAT-VCL Command Parameters
REPT-OPSTAT-VCL:[tid]:aid_vcl:[ctag][:];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
aid_vcl Virtual channel identifier for the virtual circuit. The value can be
preceded with AID=, but this is not required. Grouping and ranging are
allowed. Enter in the following format, replacing lower-case parameters
with the values given:
NTVCL-vpi-vci
LTVCL-rack-shelf-slot-circuit-vpi-vci
Grouping and ranging are allowed.
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.