Paradyne 4200 - Manual (Page 360)

C. Traps and MIBs
C-36 August 2002 4200-A2-GB20-00
Paradyne Enterprise MIBs
The following Paradyne Enterprise MIB Objects are supported:
T Paradyne DSLAM System MIB (pdn_dslam.mib)
T Paradyne Security MIB (pdn_Security.mib)
T Paradyne Syslog MIB (pdn_syslog.mib)
T Paradyne Health and Status MIB (mpe_HealthAndStatus.mib)
T Paradyne Control MIB (mpe_Control.mib) and
Paradyne Control MIB (pdn_Control.mib)
T Paradyne Configuration MIB (mpe_Config.mib) and
Paradyne Configuration MIB (pdn_Config.mib)
T Paradyne Time MIB (pdn_Time.mib)
T Paradyne mpe_ATMConf.mib
T Paradyne ReachDSL MIB (pdn_reachDSL.mib)
T Paradyne DS1 Config MIB (RFC 2495) and
Paradyne DS1 Extension MIB
Paradyne DSLAM System MIB (pdn_dslam.mib)
Support for the pdn_dslam.mib is provided to enable an NMS to access certain
objects specific to a DSLAM. The objects listed in
Table C-15, Paradyne DSLAM
System MIB Objects , are supported.
Table C-15. Paradyne DSLAM System MIB Objects (1 of 3)
Object Description Setting/Contents
loginUserId Shows the 10 most recent logins and
all active users currently accessing the
device. It also keeps a record of the
access application, user privileges, and
log-in status. Read only.
loginTime Describes the access application used
by the end user to access the device. Read only. Valid values are:
T console(1)
T telnet(2)
T ftp(3)
T web(4)
T modem(5)
loginAccessHost Contains the IP address of the NMS
station when the access application is
Telnet or FTP. Read only.