Paradyne 4200 - Manual (Page 162)

8. IP Access Commands
8-4 August 2002 4200-A2-GB20-00
DLT-IPPORT
The command DLT-IPPORT deletes an Internet Protocol port (or interface) in the
NE. All entries in the ATM Address Resolution Protocol table for a IP port must be
deleted (
DLT-ATMARPENT on page 8-2) before the port can be deleted.
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/* DLT-IPPORT:[tid]:aid_ipport:[ctag][:]: */
;
Error Response:
sid yy-mm-dd hh:mm:ss
M c DENY;
/* DLT-IPPORT:[tid]:aid_ipport:[ctag][:]: */
aid:ERRCDE=errcde
/* error description */
;
Table 8-3. DLT-IPPORT Command Parameters
DLT-IPPORT:[tid]:aid_ipport:[ctag][;];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
aid_ipport Access identifier of the IP port to be entered. The value can be
preceded with AID=, but this is not required. The valid values are:
ATM-1: First IP-over-ATM interface in the NT
ATM-2: Second IP-over-ATM interface in the NT
ETH-1: First Ethernet interface in the NT
Grouping is allowed and ALL may be used.
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.