Paradyne 4200 - Manual (Page 204)

10. Fault Commands
10-12 August 2002 4200-A2-GB20-00
RTRV-ALM-T1
The RTRV-ALM-T1 command retrieves current alarms for selected DS1 facilities.
Table 10-7. RTRV-ALM-T1 Command Parameters
RTRV-ALM-T1:[tid]:aid_ds1:[ctag]::[ntfcde],,[srveff],[locn]
,[dirn];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] The identification of the target NE. TID is optional and has a default
value of null. The NE's SID code is the only other valid value.
aid_ds1 Access Identifier for the DS1 facility. Enter in the following format,
replacing lower-case parameters with the values given:
NTT: circuit
circuit: DS1 circuit on the NT (1
−
4)
[ctag] The correlation tag that correlates an input command with its associated
output response(s). It is assigned by the originator of the command. The
value is limited to six characters, which may be an identifier or a decimal
numeral. It is optional with a default of 0.
[ntfncde] Notification code. Valid values are:
CR: Critical alarm
MJ
:
Major alarm
MN: Minor alarm
Grouping is allowed. If no value is specified, ALL is assumed.
[serveff] Service effect. Valid values are:
SA: Service affecting
NSA: Not service affecting
Grouping is allowed. If no value is specified, ALL is assumed.
[locn] Location of the condition. Valid value is NEND (Near End).
[dirn] Direction of the condition. Valid value is RCV (Receive).