Paradyne 4200 - Manual (Page 84)

3. ADSL Facility Commands
3-48 August 2002 4200-A2-GB20-00
Table 3-38. RTRV-PROFILE-ADSLDNALM Response Parameters (1 of 2)
Parameter Explanation
tid Target NE identification
yy-mm-dd Year, month, and day
hh:mm:ss Hour, minute, and second
M Message generated in response to an input command
c If provided, ctag; otherwise 0
COMPLD Completed
DENY Input command is denied
/* */ Enclosed are human readable comments – unspecified format
adsl_profile_id As described for command parameters (see Table 3-37,
RTRV-PROFILE-ADSLDNALM Command Parameters ), except that ALL
is not used.
profile_scope As described for command parameters (see Table 3-37,
RTRV-PROFILE-ADSLDNALM Command Parameters ).
profile_name A string of up to 32 characters that uniquely identifies the profile within
its scope.
[adslprof_nblk] ADSL parameter block containing one or more of the following named
parameters (separated by commas):
LOFS-L: Loss Of Frame Seconds (line). SNMP trap and TL1
autonomous message are sent if the number of LOFS events in a
15-minute interval meets or exceeds the selected value (0
−
900
seconds, where 0 disables the messages). The default is 0.
LPRS-L: Loss Of Power Seconds (line). SNMP trap and TL1
autonomous message are sent if the number of LPRS events in a
15-minute interval meets or exceeds the selected value (0
−
900
seconds, where 0 disables the messages). The default is 0.
ES-L: Errored Seconds (line). SNMP trap and TL1 autonomous
message are sent if the number of ES events in a 15-minute interval
meets or exceeds the selected value (0
−
900 seconds, where 0 disables
the messages). The default is 0.
SES-L: Severely Errored Seconds (line). SNMP trap and TL1
autonomous message are sent if the number of SES events in a
15-minute interval meets or exceeds the selected value (0
−
900
seconds, where 0 disables the messages). The default is 0.
UAS-L: Unavailable Seconds (line). SNMP trap and TL1 autonomous
message are sent if the number of UAS events in a 15-minute interval
meets or exceeds the selected value (0
−
900 seconds, where 0 disables
the messages). The default is 0.
INCRATE-F: Increasing Rate (fast channel). SNMP rate change trap
and TL1 autonomous message are sent if the current rate is
≥
the
previous rate plus this threshold (0-2176 kbps in 32 kbps increments,
where 0 disables the messages). The default is 0.