4 relt groups – GE Industrial Solutions Entellisys 5.0 User Manual User Manual
Page 148
Reduced Energy Let-Thru Mode
144
8
3. The RELT “Key” dialog box will appear. Click the Turn off button.
NOTE: The Administrator login can clear keys from any initiating user except FlexLogic. The
Administrator login can not clear breakers whose initiating user was a RELT group. (See
Figure 8-4 Reduced Energy Let-Thru Logon Dialog
4. Type in the user ID and password to disable RELT
8.1.4 RELT Groups
RELT Groups are designed to offer protection options to the user. RELT Groups is a method by
which the administrator can setup breaker associations. This enables users, when selecting a
single breaker, the option of automatically selecting all other associated breakers.
When a user requests Single-point RELT on a breaker configured as an “initiating” breaker, the
user is offered a choice between Load Protection and Breaker Protection.
Initiating Breaker: The breaker which, when issued a Single-point RELT command, will give
the user the option of also changing the settings on the Member Breakers to RELT settings.
Member Breaker: Breakers associated with the Initiating Breaker.
Load Protection
When a user enables/disables Single-point RELT on a specific breaker AND selects Load
Protection only the selected breaker will use RELT settings.
Breaker Protection
When a user enables/disables Single-point RELT on a specific breaker AND selects Breaker
Protection, all grouped breakers will also be enabled/disabled at the same time. (See
Setup of
RELT Groups
below)
NOTE: In order to turn off the entire group, the RELT “key” must be removed from the initiating
breaker.
Examples