GE Industrial Solutions Entellisys 5.0 User Manual - Manual (Page 280)

Alarms and events 268
A
ZSI Zone 1…4 Enabled ZSI functionality for zone 1…4 has been enabled
ZSI Zone 1…4 Disabled ZSI functionality for zone 1…4 has been disabled
Protection Suspended ZSI File
Error Bad or missing ZSI configuration file, functionality is
suspended Contact GE Post Sales Service (see How to
contact us on page 2 ).
Caution CPU Not Rcv From
Messngr The CPU is not receiving data from a Messenger Check Ethernet connection between the
Entellisys Messenger and switch, and the
connection between the switch and CPU.
Verify that Messenger is powered on and
operating.
CPU Receiving From Messngr The CPU is receiving data from a Messenger
Attention Discrete IO Error
FlexLogic Disabled Number of discrete I/O cards detected by CPU does
not match number that it has been programmed to
expect Contact GE Post Sales Service (see How to
contact us on page 2 ).
Attention Memory CRC Error
Replace CPU CRC error has been detected in the CPU memory,
CPU should be replaced Contact GE Post Sales Service (see How to
contact us on page 2 ).
CPUA Assumes Control Logic CPUA is running the control scheme
CPUA Relinquishes Control Logic CPUA is no longer running the control scheme
CPUB Assumes Control Logic CPUB is running the control scheme
CPUB Relinquishes Control Logic CPUB is no longer running the control scheme
Attention Duplicate CPU IDs
Found Both CPUs have the same ID Contact GE Post Sales Service (see How to
contact us on page 2 ).
Note CPU Internal Error 1 CPU detected an internal error Contact GE Post Sales Service (see How to
contact us on page 2 ).
Note CPU Internal Error 2 CPU detected an internal error Contact GE Post Sales Service (see How to
contact us on page 2 ).
Note CPU Internal Error 4 CPU detected an internal error Contact GE Post Sales Service (see How to
contact us on page 2 ).
Table A-6 CPU Status Events
Event Description Notes and Troubleshooting tips