GE Industrial Solutions Entellisys 5.0 User Manual User Manual
Page 274
Alarms and events
262
A
Attention: Flash File Error in
[CPU A/B/Messngr]. Unable to
disable Flash Pgm
Mode.Replace CPU
Contact GE Service for CPU replacement
Contact GE Post Sales Service (see
Caution: Firmware Dwnld
Failed. Err Reading Messnger
Status for [Breaker(s)]
An error was detected in confirming the status of a
Messenger prior to upgrading its firmware.
Contact GE Post Sales Service (see
Caution: Firmware Dwnld
Failed. Err Reading Messnger
Status during Switch for
[Breaker(s)]
An error was detected in confirming the status of a
Messenger after its firmware has been updated.
Contact GE Post Sales Service (see
Caution: Settings Update
Failed.Retry will Occur in 30
minutes
An attempt to update the local settings file was
unsuccessful and a retry will be attempted in the
specified time period.
If this error is repeated, Contact GE Post Sales
Service (see
Caution: IP Error X For IP
Address [n.n.n.n]
The HMI encountered an error in establishing a
TFTP session with a CPU.
Note: FTP Error X
An error has occurred during FTP protocol transfer
with a CPU. Contact GE Service.
Contact GE Post Sales Service (see
Note: TFTP Error X
An error has occurred during TFTP protocol transfer
with a CPU. Contact GE Service.
Contact GE Post Sales Service (see
HMI File [Name] Published OK
The HMI successfully updated the specified file in
the CPU
HMI File [Name] Retrieved OK
The HMI successfully retrieved the specified file
from the CPU
Caution: Error Publishing File
[Name]. Retry
An error has occurred attempting to update the
specified file and a retry will be attempted
Caution: Error Retrieving File
[Name]. Retry
An error has occurred attempting to retrieve the
specified file and a retry will be attempted
Upgrades Downloaded to CPU
OK
The HMI successfully updated the available option
programming for the CPU.
Caution: Upgrades Download
Failed.Unable to Download to
CPU
The HMI was unable to update the available option
programming for the CPU.
Contact GE Post Sales Service if repeated
attempts fail (see
).
Setting File Updated for
CPU[A/B]
The settings file has been successfully updated for
the specified CPU.
Can't Update Setting File for
CPU[A/B]
The settings file for the specified CPU could not be
updated.
IP Address in CPUA Written As
[n.n.n.n] From [n.n.n.n]
The IP address in CPU A has been changed as
specified.
Table A-4 HMI/CPU Communications Related Events
Event
Description
Notes and Troubleshooting tips