Teledyne GFC-7000T - Trace CO2 Analyzer - manual User Manual
Page 125
Operating Instructions
Model GFC7000TA Carbon Dioxide Analyzer
Teledyne Analytical Instruments
107
Press the following touchscreen buttons to select a communication mode for one of the com Ports, such
as the following example where HESSEN PROTOCOL mode is enabled:
Continue pressing next until …
SETUP X.X
PRIMARY SETUP MENU
CFG DAS
RNGE
PASS CLK
MORE
EXIT
SETUP X.X
SECONDARY SETUP MENU
COMM
VARS DIAG ALRM
EXIT
SAMPLE* RANGE = 500.000 PPM CO2 =X.XXX
< TST TST > CAL
SETUP
SETUP X.X
COMMUNICATIONS MENU
ID INET
COM1
COM2
EXIT
SETUP X.X
COM1 MODE:0
SET>
EDIT
EXIT
SETUP X.X
COM1 QUIET MODE: OFF
NEXT
OFF
ENTR EXIT
SETUP X.X
COM1 HESSEN PROTOCOL : ON
PREV NEXT
ON
ENTR EXIT
SETUP X.X
COM1 HESSEN PROTOCOL : OFF
PREV NEXT OFF
ENTR EXIT
Use PREV and NEXT to
move between available
modes.
A mode is enabled by
toggling the ON/OFF
button.
Select which COMM
port to configure
EXIT
returns to
the previous
menu
ENTR
accepts the new
settings
EXIT
ignores the new
settings
The sum of the mode
IDs of the selected
modes is displayed here