Teledyne GFC-7000T - Trace CO2 Analyzer - manual - Manual (Page 279)

ESD Model GFC7000TA Carbon Dioxide Analyzer
Teledyne Analytical Instruments 261
11.4.2.5. Packing Components for Return to Teledyne Instruments Customer
Service.
Always pack electronic components and assemblies to be sent to Teledyne Instruments Customer
Service in anti-ESD bins, tubes or bags.
WARNING
 DO NOT use pink-poly bags.
 NEVER allow any standard plastic packaging materials to touch the electronic
component/assembly directly
 This includes , but is not limited to, plastic bubble-pack, Styrofoam peanuts,
open cell foam, closed cell foam, and adhesive tape
 DO NOT use standard adhesive tape as a sealer. Use ONLY anti-ESD tape
1. Never carry the component or assembly without placing it in an anti-ESD bag or bin.
2. Before using the bag or container allow any surface charges on it to dissipate:
 If you are at the instrument rack, hold the bag in one hand while your wrist strap is connected to
a ground point.
 If you are at an anti-ESD workbench, lay the container down on the conductive work surface.
 In either case wait several seconds.
3. Place the item in the container.
4. Seal the container. If using a bag, fold the end over and fastening it with anti-ESD tape.
 Folding the open end over isolates the component(s) inside from the effects of static fields.
 Leaving the bag open or simply stapling it shut without folding it closed prevents the bag from
forming a complete protective envelope around the device.
NOTE
If you do not already have an adequate supply of anti-ESD bags or containers available, Teledyne
Instruments’ Customer Service department will supply them. Follow the instructions listed above
for working at the instrument rack and workstation.
: